Welcome Guest! Log in
×

Notice

The forum is in read only mode.
Stambia versions 2.x, 3.x, S17, S18, S19 and S20 are reaching End of Support January, 15th, 2024. Please consider upgrading to the supported Semarchy xDI versions. See Global Policy Support and the Semarchy Documentation.

The Stambia User Community is moving to Semarchy! All the applicable resources have already been moved or are currently being moved to their new location. Read more…

Topic-icon Question unable to restart etl from restart point

More
16 Apr 2019 06:46 #1 by hyesane
unable to restart etl from restart point was created by hyesane
Hi Team,

We have set up restart point in
This attachment is hidden for guests.
Please log in or register to see it.
etl to resume elt in case it fails or stuck at some places. But even after setting setting restart point it directly goes few steps ahead to give error. Please check attached PDF for complete details with screen shots.

This message has an attachment file.
Please log in or register to see it.

More
16 Apr 2019 09:39 #2 by Thomas BLETON
Replied by Thomas BLETON on topic unable to restart etl from restart point
Hello,
If i read well the PDF file (not sure because the screenshot's compression rmoved details), the step "UPDATE GV360_SHELL_RUN STATUS" is set as "Close restart point". So the restart sequence ends on this action.
All the steps have terminated without error until the "throw error" step, which is outside the Open/Close restart sequence.
So when restarting the session it will start from "throw error".
If you want to restart from a previous step then "Throw error" must be included between an Open and a Close action.