Welcome Guest! Log in


You can find below the major changes and improvements of the SAP Connector 1.0

The connector download section can be found at this page.

 

What's new in 1.0.15?

Prerequisites:
  • SAP Templates 2019-10-11 or higher
  • SAP Installation Resources 2019-10-11 or higher

 

Connector improvement for SAP Datasources

The whole mechanism for reading data from SAP Datasources has been revised and changed, for better security, performances, and support.

SAP Datasources data is now retrieved directly from SAP RFCs instead of HTTP, for better compatibility and support with SAP.

Make sure to read carefully the migration section of the installation guide shipped with "SAP Installation Resources" archive if you want to use this new mechanism.

There are important migration points to know about the migration from previous mechanism.

 

Connector improvement for SAP Tables

The whole mechanism for reading and writing data from and to SAP Tables has been revised and changed, for better security, performances, and support.

All communications with SAP Tables are now performed directly from SAP RFCs which have been revised and reworked, for better performances and support with SAP.

Make sure to read carefully the migration section of the installation guide shipped with "SAP Installation Resources" archive if you want to use this new mechanism.

There are important migration points to know about the migration from previous mechanism.

 

What's new in 1.0.14?

Connector improvement for datasource

Stambia's SAP technology file has been updated for filters and joins to be automatically created with "staging area" execution location when they are performed on SAP DataSources.

This has been changed to avoid any issue and misconfiguration as SAP does not support performing this directly on source.

 

What's new in 1.0.13?

Bug fixes

IDOC Reverse

This version fixes an issue happening when reversing decimal fields, which were reversed with incorrect length and precision in some situations.

Reverse has been modified to fix this issue: length and precision should now be correctly reversed.

That information being retrieved from SAP Table 'DD04L', make sure that the user reversing Metadata has permission to access data of this table.

 

 

 

You have no rights to post comments

Articles

Suggest a new Article!